Gravure printing

  • When high adhesiveness is required, please use a two-component ink. When selecting an ink, please consult with the ink manufacturer.
  • The basic printing conditions should be set similar to those of BOPP film printing.
  • To avoid poor centering, set the tension at the lowest possible level.
  • Immediately after putting the paper through the dryer, cool the YUPO paper to as close as room temperature as possible.
  • Set the printing conditions in such a manner that the dryer air does not exceed 80℃. Do not attempt to improve drying efficiency by increasing the temperature. More effective results will be achieved by adjusting the air speed or air volume.
  • For solid patterns, white areas may occasionally bleed through. Perform a test-print to confirm beforehand.